Sword Belt Shoulder Strap (Sam Brown) with Brass Hook

$25.00
(No reviews yet) Write a Review
SKU:
BLT026

Made from 7 oz. leather with large brass sword hanger hook in the front and small adjustment hook in the rear with pressure keeper. All straps are custom sized. Available in black or russet.  White buff is also available for $13.00 more.

How to measure your SHOULDER STRAPS

Use a fabric style tape measure (links are provided as example):

The Enlisted Officer shoulder strap comes with a hook for sizing – with 5 holes to use for adjustment.

Please give a point-to-point measurement by using the directions below:

1 – Start your measurement at approximately 8" to the left side of your navel. It should sit on your left hip.** If you are larger than a 48" waist, you may need to add another inch so it hangs properly from your left hip in front around to the same left hip in the back, still keeping level with your navel.

2 – Put the sling over your right shoulder – putting it in place near your neck so as not to give it improper slack.

3 – Finish the measurement at your back left hip to the left of your spine, again in line with your navel. This is where the sling hooks on the back of the belt. It should be in line with the buttons on the back of your frock, which is where the belt is supposed to sit.

4 – An approximate guide number for shorter reenacters is about 42", and up to 46-47" for an average reenacter, right up to 50" if you are heavier. We can cut them any way you wish.

**All other measurements leave to us.

— Dell's Leather Works

 

Historical Citation:

This buckle is copied from an original in the collection of Steve Workman, retired Regimental Quartermaster, National Regiment.